Displaying Dhcp Relay Configuration - ADC CUDA 3 Administration Manual

Displaying DHCP Relay Configuration

Cuda 12000 IP Access Switch CLI-based Administration Guide
MTA Gateway Address — The MTA Gateway address that the DHCP
Relay requests on behalf of the MTA device. This is the same address
as the Gateway Address configured on the interface.When a DHCP
Request is received and it is from the MTA device, then the MTA
Gateway Address is used by the DHCP Relay.
Enable or disable agent options.
You can display the current DHCP relay configuration using the show
dhcp-relay command from within interface cable <c/s/i> mode, as shown in
the following example:
cli:192.168.208.3:interface:cable:csi(1/1/1)# show dhcp-relay
dhcp-relay
Add Agent Options
Drop Mismatch
Max. Pkt. Len.
Relay Mode
Server Address
----------------
giAddresses:
CM
CPE
MTA
cli:192.168.208.3:interface:cable:csi(1/1/1)#
Displaying DHCP Relay Configuration
enable
enable
disable
576
replace
201.1.1.1
201.1.2.1
0.0.0.0
245