Enabling And Disabling Ip Packet Filtering - ADC CUDA 3 Administration Manual

Enabling and Disabling IP Packet Filtering

Task
1. Enable packet filtering on the
2. Disable packet filtering on the
Cuda 12000 IP Access Switch CLI-based Administration Guide
Whenever you apply an access-list to an interface using the access-class
command IP filtering is automatically enabled.
You can disable IP filtering so that all packets are permitted to cross the
interface. You must disable access lists manually; IP filtering is not
automatically disabled when access lists are removed.
For each interface, you can enable filtering of incoming packets, as well as
outgoing packets. To do so, perform the following tasks within interface
<c/s/i> mode:
current interface.
current interface.
Enabling and Disabling IP Packet Filtering
Command
ip filter {in | out} enable
ip filter {in | out} disable
329