ADC CUDA 3 Administration Manual page 30

Ip access switch cli-based administration guide
Table of Contents

Advertisement

28
C
1: C
12000 O
HAPTER
UDA
VERVIEW
Feature
Description
CableOnce
The system supports a CableOnce design that allows you to
TM
Network
cable directly to the appropriate connector fixed to the rear
Connections
of the chassis, or slot backplate. Cabling directly to these
stationary connectors, instead of to the modules
themselves, allows module replacement without recabling.
You remove a module and then insert a new one while the
cables remain attached to the system. This blind-mate
design also lets you pre-cable chassis slots to prepare them
in advance for module installation at a later time.
Hot-swappable
All system modules can be replaced while the system is
Modules
running without interruption to other interconnected
networks. Both application modules and Management
modules are hot-swappable.
Modules
The Cuda 12000 IP Access Switch chassis comprises 14 slots. Twelve of the
slots are for application modules and two of the slots are for management
modules, which control the operations of the chassis. The following is a list
of the modules supported by the Cuda 12000 IP Access Switch:
Management Module
DOCSIS Modules
- 1x4 DOCSIS Module
- 1x4 DOCSIS SpectraFlow Module
- 1x6 DOCSIS SpectraFlow Module with Spectrum Management
EuroDOCSIS Modules
- 1x4 EuroDOCSIS Module
- 1x4 EuroDOCSIS SpectraFlow Module
- 1x4 EuroDOCSIS SpectraFlow Module with Spectrum Management
Egress Modules (Route Server Modules)
- Octal 10/100 Ethernet SpectraFlow Module
- Gigabit Ethernet SpectraFlow Module
- Packet over SONET (POS) SpectraFlow Module
ADC Telecommunications, Inc.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cuda 12000

Table of Contents