Ospf Configuration Task Overview; Configuring Ospf Global Parameters - ADC CUDA 3 Administration Manual

OSPF Configuration Task Overview

Configuring OSPF Global Parameters

Cuda 12000 IP Access Switch CLI-based Administration Guide
Configuration of the Cuda 12000 within an OSPF network includes:
Configuring OSPF Global Parameters
Adding OSPF Areas
Removing OSPF Areas
Configuring OSPF on IP Interfaces
Removing OSPF from IP Interfaces
Configuring OSPF Virtual Interfaces
Removing OSPF Virtual Interfaces
Configuring OSPF Neighbor Traps
OSPF Global Parameters provide information about this router to other OSPF
routers in the autonomous system. These global parameters include:
Table 14-3 OSPF Global Parameters
Parameter
OSPF Router ID
Autonomous System Boundary
Router (ASBR)
OSPF Administration State
OSPF Neighbor State and OSPF
Virtual Neighbor State Traps
Configuring OSPF
Description
The OSPF router ID uniquely identifies this
router to other routers in the autonomous
system. It is recommended that you use
one of the system's IP addresses or define
an IP address that is unique to the network.
Configures this router as an ASBR.
Enables or disables the OSPF protocol on a
system-wide basis. If enabled, this router
participates in the OSPF network; otherwise
the system does not participate.
Enables or disables sending of OSPF
neighbor state and OSPF virtual neighbor
state traps. Refer to "Configuring OSPF
Neighbor Traps" on page 318 for more
information.
301