ADC CUDA 3 Administration Manual page 304

302 C 14: C
HAPTER ONFIGURING
IP
OSPF global parameters are configured within router ospf mode. You
configure OSPF global parameters by performing the following tasks:
Task
1. Enter router-ospf mode.
2. Define the OSPF router ID for this
system.
3. Configure this router as an ASBR.
4. Display OSPF global parameters to
verify configuration. You can
display OSPF global parameters
from within any mode.
For more information on these commands, refer to the Cuda 12000 IP
Access Switch CLI Reference Guide.
Example
cli:172.16.19.10:root# router ospf
mode: router:ospf
cli:172.16.19.10:router:ospf# router-id 201.1.1.1
cli:172.16.19.10:router:ospf# asbr
cli:172.16.19.10:router:ospf# show ospf
Admin Status
TOS Support
Router Id
ABR Status
ASBR Status
Report ospf-nbr-state
Report ospf-virt-nbr-state
Command
router ospf
router-id <ip address>
Note that you cannot set the router ID
to 0.0.0.0 or 255.255.255.255.
asbr
Note that ASBR is disabled by default. If
you configure this router as an ASBR,
and then later decide to disable ASBR,
issue this command:
no asbr
show ospf
Enabled
False
201.1.1.1
False
True
Disabled
Disabled
ADC Telecommunications, Inc.