Global Commands - ADC CUDA 3 Administration Manual

42 C 2: A
HAPTER BOUT THE

Global Commands

C L I
OMMAND INE NTERFACE
Global commands can be used anywhere in the CLI, regardless of your
current command mode. Table 2-1 lists global commands as they appear
when you type help at the command prompt. Note that the help command
output displays many commands in their abbreviated form.
Table 2-1 Global Commands
Command
basmonitor
boot
clear
cm-filter-default
cpe-control
connect
echo
enable
help
interface
ip
no
ping
prov-server
q
quit
root
router
Description
Starts the system monitor.
Enables, disables, or reboots a module in an
application slot.
Clears a specified system resource (depending on the
specified argument), such as ARP cache or statistics
counters.
Sets the default cable modem filter values for the
system.
Sets the default subscriber management values for the
system.
Connects you to another Cuda 12000 IP Access Switch
chassis.
Echoes a comment so that it displays.
Enables a user session.
Displays CLI command help.
Changes you to interface mode.
Configures IP parameters for the system.
Specifies the no form of a command.
Enables you to the send an ICMP echo request packet
to a destination to determine if it is reachable.
Changes you to provisioning server mode. This
command is useful only if the FastFlow Broadband
Provisioning Manager is installed on your Cuda 12000
IP Access Switch.
Shortened form of quit.
Enables you to exit from the CLI.
Changes you to root mode.
Changes you to router mode.
ADC Telecommunications, Inc.