Browsing Cable Modem And Mta Status - ADC CUDA 3 Administration Manual

Browsing Cable Modem and MTA Status

Cuda 12000 IP Access Switch CLI-based Administration Guide
The Cuda 12000 supports the retrieval and display of status information that
is maintained by individual cable modems and MTAs connected to the HFC
network. This information is useful when you have to monitor the network
and troubleshoot network problems.
To retrieve and display this status information:
1. Issue the interface <c/s/i> command to access interface mode for the
CMTS interface used by the cable modems and MTAs of interest.
2. Issue show modem commands (with the appropriate arguments) to
retrieve this information, as shown in the following table:
Table 21-3 Commands for Accessing Cable Modem and MTA MIB Tables
Command
show modem <mac address> cm mac
show modem <mac address> cm
service
show modem <mac address> cm status CM Status (docsIfCMStatusTable).
show modem <mac address> cm
downstream
show modem <mac address> cm
upstream
show modem <mac address> cm
signal-quality
show modem <mac address> cm
qosprofile
show modem <mac address> cm
bpi-base
show modem <mac address> cm
bpi-tek
Browsing Cable Modem and MTA Status
MIB Table or Group
CM MAC (docsIfCmMacTable).
Refer to Table 21-4 on page 528.
CM Service
(docsIfCMServiceTable). Refer to
Table 21-5 on page 528.
Refer to Table 21-6 on page 529.
Downstream
(docsIfDownstreamChannelTable).
Refer to Table 21-7 on page 530.
Upstream
(docsIfUpstreamChannelTable).
Refer to Table 21-8 on page 531.
Signal Quality
(docsIfSignalQualityTable). Refer to
Table 21-9 on page 532.
QOS (docsIfQosProfileTable). Refer
to Table 21-10 on page 533.
BPI Base (docsBPICMBaseTable).
Refer to Table 21-11 on page 534.
BPI TEK (docsBPICMTEKTable).
Refer to Table 21-12 on page 538.
525