ADC CUDA 3 Administration Manual page 293

Cuda 12000 IP Access Switch CLI-based Administration Guide
Descriptions of the RIP parameters that you configure are listed below.
Table 14-2 RIP Parameters
Parameter
IP Address
Send Version
Receive Version
Cost
Authentication ON
Authentication Type
Send Default Only
Send Default Also
Description
IP address of the current interface.
Version of RIP packets this router will send
on this interface ((RIP v1), (RIP v2), (RIPv1 or
RIPv2) or none).
Versions of RIP packets the router will
accept on this interface ((RIP v1), (RIP v2),
(RIPv1 or RIPv2) or none).
Cost or metric of the current interface. This
cost is added to all routes that are learned
from this interface, except the default route
if a default cost is specified. Routers use cost
values to select the best route to a
destination. When multiple routes to a
destination exist, routers select the route
with the lowest cost.
Whether authentication is performed on RIP
packets received on the interface.
Method of authenticating RIP packets on
this interface. If authentication is performed
on the interface, it specifies the type of
authentication (md5, simple password, or
no authentication) that RIP uses as a security
measure to ensure that this interface is
exchanging information with proper
neighbors.
Whether the Cuda 12000 advertises only its
default route on the interface.
Whether the Cuda 12000 advertises its
default route on the interface (in addition to
other routes). The default route is the one
that the Cuda 12000 selects when it does
not have a specific route to a destination
network, subnetwork, or host.
Configuring RIP 291