ADC CUDA 3 Administration Manual page 577

Command
qos permission modems
ranging-attempts <value>
shared-secret [ascii] <string>
sync-interval <value>
ucd-interval <value>
upstream <port number>
channel-width {200 | 400| 800 |
1600 | 3200}
upstream <port number>
data-backoff <start value> <end
value>
upstream <port number> frequency
<value>
upstream <port number> map
{init-maint-size-adjust <value> |
max-ranging-invitations <value> |
min-req-region <value> |
ucd-grant-size <value>}
upstream <port number>
minislot-size <value>
upstream <port number>
modulation-profile <profile index>
upstream <port number> no
shutdown
Cuda 12000 IP Access Switch CLI-based Administration Guide
Cable Interface Administration Commands
Mode
interface:cable:csi
interface:cable:csi
interface:cable:csi
interface:cable:csi
interface:cable:csi
interface:cable:csi
interface:cable:csi
interface:cable:csi
interface:cable:csi
interface:cable:csi
interface:cable:csi
interface:cable:csi
Description
Enables cable modem registration
access to the QoS tables on the
current cable interface.
Maximum number of ignored
ranging invitations allowed by this
cable interface.
Use this command to configure
cable modem authentication by
defining the CMTS shared secret.
The shared secret is defined as a
hex string. Any modem that wants
to register with the CMTS must
return this known string (the
shared secret).
Configures the synchronization
interval for the current cable
interface. Valid range: 1 – 200
milliseconds.
Configures the UCD interval for
the current cable interface. Valid
range: 1 – 2000 milliseconds.
Sets the channel width, in kHz, for
the specified upstream port.
Sets a fixed start value for initial
backoff on the upstream channels.
Sets the upstream signal
frequency.
Tunes map generation for the
specified upstream port.
Sets the number of 6.25
microsecond ticks in each
upstream minislot.
Specifies the modulation profile
that you want the port to utilize.
Sets the channel status for the
specified upstream port to up.
575