ADC CUDA 3 Administration Manual page 281

cli:192.168.208.3:root# interface 1/11/1
mode: interface:ethernet:csi(1/11/1)
cli:192.168.208.3:interface:ethernet:csi(1/11/1)# ip route 222.2.1.0
255.255.255.0 222.2.2.1
cli:192.168.208.3:interface:ethernet:csi(1/11/1)# show ip
row count: 8
Protocol Route
Type
-------- ------ --------------- --------------- --------------- ------ ------
Local Local
Local Local
Net Mgmt Remote 199.3.2.0
Local Local
Local Local
Net Mgmt Remote 222.2.1.0
Local Local
Net Mgmt Remote 222.2.3.0
Cuda 12000 IP Access Switch CLI-based Administration Guide
Perform the following tasks to add a static route to the routing table:
Task
1. Enter configuration mode for the
interface on which you want to
add the route.
2. Add the static route.
Example
Destination
155.144.1.0
199.3.1.0
201.1.1.0
201.1.2.0
222.2.2.0
Command
interface {<c/s/i> | loopback}
ip route <dest-network> <mask>
<gateway-ip-address> [<metric>]
Net Mask Next Hop
255.255.255.0 155.144.1.1
255.255.255.0 199.3.1.1
255.255.255.0 199.3.1.3
255.255.255.0 201.1.1.1
255.255.255.0 201.1.2.1
255.255.255.0 222.2.2.1
255.255.255.0 222.2.2.2
255.255.255.0 222.2.2.1
Configuring Static Routes
Metric C/S/I
0 1/8/1
0 131/1/1
1 131/1/1
0 1/1/1
0 1/1/1
1 1/11/1
0 1/11/1
1 1/11/1
279