ADC CUDA 3 Administration Manual page 423

Cuda 12000 IP Access Switch CLI-based Administration Guide
Task
3. Disable the differential
encoding.
FEC-tbytes
The Fec-tbytes parameter is the number of errored bytes that can be
corrected in forward error correction code. By default, FEC-tbypes is set at
zero. The value of zero indicates no correction is employed. Acceptable
values are 0 to 10. The number of check bytes appended will be twice the
value that is set.
You set the FEC-tbypes by performing the following tasks:
.
Task
1. Enter cable interface
mode.
Configure FEC error
correction.
Defining Modulation Profiles
Command
modulation-profile <profile number>
interval-usage {initial | long | request | short |
station} no-diff
Command
interface cable <c/s/i>
modulation-profile <profile number>
interval-usage {initial | long | request | short |
station} fec-tbytes <0..10>
421