ADC CUDA 3 Administration Manual page 310

308 C 14: C
HAPTER ONFIGURING
Task
1. Configure the cost for this OSPF
interface.
2. Configure the dead-interval for this
OSPF interface, in seconds. When
OSPF is initially enabled on the
interface, the dead interval defaults to
40 seconds.
The Cuda 12000 and all of its OSPF
neighbors on the IP interface you are
configuring must have matching dead
interval values. Otherwise, the
neighbors cannot form adjacencies.
3. Configure the Hello interval for the
current OSPF interface, in seconds.
When OSPF is initially enabled on the
interface, the hello interval defaults to
10 seconds.
The Cuda 12000 and all of its OSPF
neighbors on the IP interface you are
configuring must have matching hello
interval values. Otherwise, the
neighbors cannot form adjacencies.
IP
Configuring OSPF Parameters for an IP Interface
After you have entered IP address configuration mode and assigned an
area ID to the IP interface, you can then configure OSPF parameters on the
interface.
To do so, perform the following tasks within IP address configuration mode:
Command
ip ospf cost <number>
ip ospf dead-interval <seconds>
ip ospf hello-interval <seconds>
ADC Telecommunications, Inc.