ADC CUDA 3 Administration Manual page 499

Cuda 12000 IP Access Switch CLI-based Administration Guide
Table 20-1 Subscriber Management Global Filtering Parameters
Parameter
Group number
Filter number
Deny or Permit
Source IP Address
Source IP Mask
Destination IP Address
Destination IP Mask
Configuring Filter Groups
Description
Group number specifies the ID of the filter
group to which you want the filter to belong.
Allowable group number values range from 1
to 60. A value of 0 means that no filtering is
performed.
Filter number specifies the index number for
the filter within the group. Allowable values
range from 1 to 40.
Specify packet filtering for the particular
matching criteria:
deny: drop packets that match the filter
criteria.
permit: forward packets that match the
filter criteria.
The filter attempts to match the source IP
address to the IP address in the IP packet. If
the addresses match, the filter is applied to
the packet.
Bit mask that applies to the source IP address
prior to matching. The source IP address and
mask are the matching criteria for the packet.
By default, the source IP address and mask
specify a filter that matches all source
addresses. This mask entry is not necessarily
the same as the subnet mask.
The filter attempts to match the destination IP
address to the IP address in the IP packet. If
the addresses match, the filter is applied to
the packet.
Bit mask that applies to the destination IP
address prior to matching. The destination IP
address and mask are the matching criteria
for the packet. By default, the destination IP
address and mask specify a filter that matches
all destination addresses. The mask entry is
not necessarily the same as the subnet mask.
497