Cable Interface Administration Commands - ADC CUDA 3 Administration Manual

Cable Interface Administration Commands

Command
admission-control {enable | disable}
cm modify upstream
<new-upstream-channel>
{<ip-address> | <mac-address> |
<sid>}
downstream frequency
<freq-number>
downstream interleave-depth
<number>
downstream modulation
{qam64 | qam256}
downstream no shutdown
downstream shutdown
downstream transmit-power
<number>
flap-list aging <value>
flap-list clear
Cuda 12000 IP Access Switch CLI-based Administration Guide
Table A-8 Cable Interface Administration Commands
Mode
interface:cable:csi
interface:cable:csi
interface:cable:csi
interface:cable:csi
interface:cable:csi
interface:cable:csi
interface:cable:csi
interface:cable:csi
interface:cable:csi
interface:cable:csi
Cable Interface Administration Commands
Description
Enables and disables the admission
control function.
Moves the specified cable modem
to a new upstream port. Note that
the new upstream port must be
enabled before issuing this
command.
Sets the downstream frequency on
the current cable (CMTS) interface.
Sets the downstream interleave
depth on the current cable (CMTS)
interface.
Defines the modulation type that
you want the downstream channel
on the current cable (CMTS)
interface to use — 64qam or
256qam.
Sets the downstream channel
status on the current cable (CMTS)
interface to up.
Sets the downstream channel
status on the current cable (CMTS)
interface to down.
Sets the transmit power of the
downstream channel on the
current cable (CMTS) interface.
Defines the number of days to
retain flapping activity on cable
modems connected to this cable
interface.
Resets (clears) all counters in the
cable modem flap list on the
current cable (CMTS) interface.
573