Modifying Filter Groups Per Cable Modem - ADC CUDA 3 Administration Manual

Modifying Filter Groups Per Cable Modem

Cuda 12000 IP Access Switch CLI-based Administration Guide
The Cuda 12000 allows the network administrator to temporarily modify the
matching criteria of a default filter group on a per cable modem basis.
A default filter group is modified when the network administrator feels it is
necessary to use different matching criteria for a particular cable modem or
CPE device. The modifications are applied as follows:
The filter group containing the modifications overrides the matching
criteria of the default filter group. These changes do not persist. The next
time the cable modem re-initializes, the changes are wiped out and the
cable modem uses the default filter group.
The filter group containing the modifications is a temporary assignment
and is not persisted on the Route Server.
Since a non-default filter group is not persisted, the modifications do not
overwrite the initial source matching criteria of the default filter group.
The following table lists the parameters that you set to modify global filter
groups on the Cuda 12000:
Table 20-3 Parameters for Modifying Default Filter Groups
Parameter
Group ID
IP Address
MAC Address
Modifying Filter Groups Per Cable Modem
Description
The group ID of the filter group containing the
modifications that will override the default
filter group.
The IP address of:
the cable modem, to which the filter group
containing the modifications is applied; or
the cable modem that provides network
access to the CPE, to which the filter group
containing the modifications is applied.
The MAC address of:
the cable modem, to which the filter group
containing the modifications is applied; or
the cable modem that provides network
access to the CPE, to which the filter group
containing the modifications is applied.
507