ADC CUDA 3 Administration Manual page 587

Command
snmp-server view <view-name>
<oid-tree> {included | excluded}
[storage {volatile | nonvolatile |
permanent | readonly}] [status
{enable | disable}]
Packet Over SONET (POS) Commands
Command
clear counters
clock-source {line | internal}
crc {16 | 32}
loop {line | internal}
mtu <value>
pos flag {c2 | j0} <value>
pos report lais
pos report lrdi
pos report pais
pos report plop
pos report prdi
Cuda 12000 IP Access Switch CLI-based Administration Guide
Mode
root
Table A-14 POS Commands
Mode
interface:pos:csi
interface:pos:csi
interface:pos:csi
interface:pos:csi
interface:pos:csi
interface:pos:csi
interface:pos:csi
interface:pos:csi
interface:pos:csi
interface:pos:csi
interface:pos:csi
Packet Over SONET (POS) Commands
Description
Creates an SNMP MIB view.
Description
Clears all counters on the current
POS interface.
Configures the SONET
transmission clock source.
Configures cyclic redundancy error
checking on the current POS
interface.
Configures loopback testing on
the current POS interface.
Sets the maximum transmission
unit (MTU) for the interface.
Sets values for the c2 and j0
SONET overhead bytes on the
current POS interface.
Configures the POS interface to
report line alarm indication signal
errors.
Configures the POS interface to
report line remote defect
indication errors.
Configures the POS interface to
report path alarm indication signal
errors.
Configures the POS interface to
report path loss of pointer errors.
Configures the POS interface to
report path remote defect
indication errors.
585