Ip Administration And Route Filtering Commands - ADC CUDA 3 Administration Manual

IP Administration and Route Filtering Commands

Command
access-class <list number> {in | out}
priority <priority number>
access-list <list number> {deny |
permit} <rule number> ip {<source ip
address> <source IP mask> | host <ip
address> | any } {<destination IP
address> <destination IP mask> |
host <destination ip address> | any}
[tos <tos> <tos mask>] [change-tos
<tos>]
add arp <ip-address>
<mac-address>
arp timeout <number>
clear arp-cache
clear ip igmp group
[<group-address>]
del arp <ip-address>
dhcp-authority {enable | disable}
export
Cuda 12000 IP Access Switch CLI-based Administration Guide
Table A-4 IP Administration and Route Filtering Commands
Mode
interface:cable:csi
interface:<type>:csi
interface:<type>:csi
interface:<type>:csi
interface:<type>:csi
IP Administration and Route Filtering Commands
Description
Applies filtering rules (access-lists)
to interfaces.
root A sequential set of filtering rules to
which inbound and outbound
interface:cable:csi
packets can be applied.
Adds an ARP (Address Resolution
Protocol) entry to the ARP cache
on a selected interface.
Sets the timeout for dynamic ARP
cache entries.
root Deletes all non-static ARP entries.
interface:<type>:csi
root Deletes multicast group entries.
interface:<type>:csi
Removes an ARP (Address
Resolution Protocol) entry from the
ARP cache on a selected interface.
Enables and configures DHCP
authority ranges on the current
interface. DHCP authority secures
all IP addresses Any address that
falls within the range are labelled
as DHCP within the ARP table
upon acknowledgement from the
host. This tagging of the ARP
cache entry ensures that another
MAC host cannot use the IP
address.
router:rip Enters export mode. From within
this mode you can create export
router:ospf
Routing Information Protocol (RIP)
or Open Shortest Path First (OSPF)
route filters.
565