Monitoring Snmp - ADC CUDA 3 Administration Manual

196 C 9: S
HAPTER IMPLE

Monitoring SNMP

N M P
ETWORK ANAGEMENT ROTOCOL
The show snmp command allows you to monitor SNMP activity on the
Cuda 12000. To use this command, perform the following tasks:
Tasks
1. Enter root mode.
2. Monitor SNMP activity.
The command displays the following information:
Table 9-9 SNMP Parameters and Statistics
Parameter
Contact
Name
Location
SNMP Packets
Received
Bad SNMP Version
Errors
Unknown Community
Names
Illegal Community
Names
Encoding Errors
Silent Drops
Unknown Security
Models
(SNMP)
Commands
root
show snmp
Description
The type of contact for this network. The contact is
typically a network administrator's name, extension,
and/or e-mail address.
The name of the system (sysName MIB object).
The physical location of the device (sysLocation MIB
object).
Total number of messages that the transport service
delivers to the SNMP entity.
Total number of SNMP messages that the SNMP entity
receives using an unsupported version of SNMP.
Total number of SNMP messages that the SNMP entity
receives using an SNMP community name not known
to the entity.
Total number of SNMP messages that the SNMP entity
receives that represent an SNMP operation that is now
allowed by the SNMP community named in the
message.
Total number of ASN.1 or BER errors that the SNMP
entity encounters when decoding SNMP messages.
Total number of GetRequest-PDUs,
GetNextRequest-PDUs, GetBulkRequest-PDUs,
SetRequest-PDUs, and InformRequest-PDU packets that
the SNMP entity receives and drops.
Total number of packets that the SNMP engine receives
and drops because the security model was not known
or supported by the SNMP engine.
ADC Telecommunications, Inc.