Configuring The Syslog Server - ADC CUDA 3 Administration Manual

Configuring the Syslog Server

Cuda 12000 IP Access Switch CLI-based Administration Guide
Before you manage event transmission or reporting using the syslog server,
you set the IP address of the syslog server to which your Cuda 12000 writes
system log messages, as required by DOCSIS 1.1 standards.
You may specify the IP address of the local Syslog server on your Cuda 12000
or a remote syslog server on another Cuda 12000.
To configure the IP address of the Syslog server, perform the following tasks:
Task
1. Enter root mode.
2. Specify the IP address of the syslog
server.
3. Display the syslog server IP
address. If a Syslog server IP
address does not currently exist,
the default is 0.0.0.0.
Example
cli:192.168.208.3:root# show event-config syslog
Syslog Server
cli:192.168.208.3:root#
To remove the Syslog server entry, perform the following tasks:
Task
1. Enter root mode.
2. Remove the syslog server entry.
Configuring the Syslog Server
Command
root
event-config syslog <ip-address>
show event-config syslog
0.0.0.0
Command
root
event-config syslog 0.0.0.0
205