ADC CUDA 3 Administration Manual page 195

Cuda 12000 IP Access Switch CLI-based Administration Guide
Parameter
ospf-virt-nbr-state
Modem deregistration event:
dereg-modems
Perform the following tasks to configure event notifications. Refer to the
configuration examples, below:
Tasks
1. Enter configuration mode.
2. Create an SNMP host to receive
trap messages.
3. Specify the UDP port number on
which the SNMP host will receive
traps.
4. Specify the maximum message
size (MMS), in bytes, of an SNMP
message that the SNMP engine
will transmit or receive and
process.
Configuring SNMP Event Notification Types
Description
Signifies a change in the state of an
OSPF neighbor on a virtual interface.
To send this notification type, note
that you also have to enable sending
of OSPF virtual neighbor state traps
using the report command.
A modem deregistration event refers
to the deregistration of cable
modems.
Signifies that a number or percentage
of modems have deregistered over the
deregistration time interval.
Commands
root
snmp-server host <ip address>
<community-name> {traps | informs
[timeout <seconds>] [retries
<retries>]} [version {1 | 2c | 3 {auth |
noauth | priv}]
snmp-server host <ip address>
<community-name> {traps | informs
[timeout <seconds>] [retries
<retries>]} [version {1 | 2c | 3 {auth |
noauth | priv}] udp-port <port>
snmp-server host <ip address>
<community-name> {traps | informs
[timeout <seconds>] [retries
<retries>]} [version {1 | 2c | 3 {auth |
noauth | priv}] [mms] <size>
193