Table of Contents
Advertisement
®
Intel
855GME Chipset and Intel
9.3.4
Secondary IDE Connector Requirements
Figure 98.
Connection Requirements for Secondary IDE Connector
22 Ω - 47 Ω series resistors are required on PCIRST#. The correct value should be determined
•
for each unique motherboard design, based on signal quality.
An 8.2 K Ω to 10 K Ω pull-up resistor is required on IRQ15 to V
•
A 4.7 K Ω pull-up resistor to V
•
•
Series resistors are not required but may be placed on the control and data line to improve
signal quality. Place the resistors as close to the connector as possible. Resistor values are from
33 Ω - 47 Ω .
The 10 K Ω resistor to ground on the PDIAG#/CBLID# signal is required on the Secondary
•
Connector. This change is to prevent the GPI pin from floating when a device is not present on
the IDE interface.
•
Place all resistors as close to the IDE connector as possible.
®
6300ESB ICH Embedded Platform Design Guide
Intel
3.3 is required on SIORDY.
CC
January 2007
®
6300ESB Design Guidelines
3.3.
CC
199
Advertisement
Table of Contents
