Perform A Hot Start; Figure 3-4 Status Led (D5) And Run Led Location; Figure 3-5 Display Indication (Idle) - NEC SL1100 Hardware Manual
Hide thumbs
Also See for SL1100:
- Features and specifications manual (864 pages) ,
- Programming manual (650 pages) ,
- Networking manual (292 pages)
Table of Contents
Advertisement
ISSUE 1.0
6.
Release the LOAD button.
7.
When the system has completed reloading the software (about two minutes), the RUN LED is
flashing blue on the CPU card and the connected Multiline Telephone's display will show the Time
& Date and Extension Number.
1.2.2
Perform a Hot Start
This section describes how to load system software from flash memory, and the customer data from
RAM memory.
System software is loaded from flash memory, and the customer data is loaded
from RAM memory.
To perform a Hot Start;
1.
Turn the system power off.
2.
After it has powered off, turn the power switch back to ON. Wait approximately two minutes.
3.
When the system has completed reloading the software, the RUN LED is flashing blue on the
CPU card, and the connected Multiline Telephone's display will show the Time & Date and
Extension Number as Display Indication (Idle).
Hardware Manual
Figure 3-4 Status LED (D5) and RUN LED Location
Figure 3-5 Display Indication (Idle)
SL1100
3-3
Advertisement
Table of Contents
