Installing The Modular Lan Controller; Required Tools; Preliminary Steps - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

Expansion cards and backup units
9.3.1

Installing the Modular LAN controller

Upgrade and Repair Units (URU)
Average hardware task duration: 5 minutes
Average software task duration: 5 minutes
9.3.1.1

Required tools

Preliminary and concluding steps: tool-less
●
Installing the Modular LAN controller: tool-less
●
Mounting slot brackets:
●
– Phillips PH2 / (+) No. 2 screw driver
9.3.1.2

Preliminary steps

Before installing a Modular LAN controller, perform the following steps:
Ê Disable BitLocker functionality as described in section
functionality" on page
Ê Disable boot watchdog functionality as described in section
SVOM boot watchdog functionality" on page
Ê Shut down the server as described in section
page 67.
Ê Remove the AC power cords from the PSU cable brackets and disconnect
them from the system as described in section
from the mains" on page
Ê When working on a rack-mounted server, extend it out of the rack as
described in section
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page
Ê Bring the server to its horizontal position.
420
133.
68.
"Extending the server out of the rack" on page
Upgrade and Maintenance Manual
"Disabling BitLocker
"Disabling
134.
"Shutting down the server" on
"Disconnecting the server
73.
TX300 S7 / RX350 S7
72.