Reference - Agilent Technologies PSA Series User And Programming Manual

Instrument Functions: P - Z
System
Key Path:
System
State Saved: Survives
SCPI Status Bits/
OPC Dependencies: None
Factory
Default: On (Reset by
Remote Command:
:SYSTem:COMMunicate:LAN:SCPI:SICL:ENABle OFF|ON|0|1
:SYSTem:COMMunicate:LAN:SCPI:SICL:ENABle?
Example:
SYST:COMM:LAN:SCPI:SICL:ENAB ON

4.9.6 Reference

Displays functions that control the external frequency reference.
Key Path:
System
Remote Command:
There is no remote command for this key.
4.9.6.1 Freq Ref
Specifies the frequency reference as being internal or external. If the frequency reference
is specified as internal, the frequency of the reference is automatically identified as being
10 MHz. If the frequency reference is specified as external, you must enter the frequency of
the external reference being used. If External Reference is selected, Ext Ref will appear
on the right side of the display.
The frequency of an external frequency reference is not automatically detected. If an
external frequency source is selected, the frequency of the source must be entered.
If Ext is selected, and you press
frequency will become the active function. If
selected (at 10 MHz). The Ext reference frequency is remembered and will be used again if
Ext is selected.
If the external reference is missing or out of range, or the frequency reference is unlocked,
the message "External reference missing or out of range", will appear on the
display.
262
,
SCPI Lan
and power cycle, but not saved in Instrument State.
Preset
,
System Restore Sys Defaults
, Ext will remain selected and the Ext reference
Freq Ref
.)
is pressed again, Int will become
Freq Ref
Chapter 4