Agilent Technologies PSA Series User And Programming Manual page 87

2.4.1.8 EMI Average
Selects EMI averaging detection. EMI Average detection displays the average value of
amplitude envelope. It is defined for EMI measurements by the CISPR standard and uses
the VBW filter as a low pass filter, the output of which is sampled during the bucket
interval. This functionality is quite different from the Average detector.
Key Path:
Det/Demod
Dependencies/
Couplings: Whenever the EMI Average detector is selected, the resolution bandwidths
available will be the CISPR set listed in
with RBW Set to Auto,"
to Manual," on page
The Video BW is restricted to 1 Hz while VBW is is set to Auto.
History: Firmware revisions A.06.00
Remote Command:
See "Detector" on page
Example:
DET EAV
2.4.1.9 EMI Peak
Selects peak detection. This is the same detection as the regular Peak detector. The
difference is the Auto resolution bandwidths that are available as described in
"CISPR Bandwidths with RBW Set to Auto,"
RBW Set to Manual," on page
Key Path:
Det/Demod
Dependencies/
Couplings: Whenever the EMI Average detector is selected, the resolution bandwidths
available will be the CISPR set listed in
with RBW Set to Auto,"
to Manual,"
Frequency with RBW Set to Auto," on page 88
analyzer is in
History: Added with firmware revision A.6.0
Remote Command:
See "Detector" on page
Example:
DET EPOS
Chapter 2
and Table 2-3, "CISPR Bandwidths with RBW Set
86.
79.
and
86.
and Table 2-3, "CISPR Bandwidths with RBW Set
and Table 2-4, "MIL Specifications for Bandwidth vs.
mode.
Manual:FFT
79.
Instrument Functions: A - L
Table 2-2, "CISPR Bandwidths
Table 2-3, "CISPR Bandwidths with
Table 2-2, "CISPR Bandwidths
. EMI Peak
Det/Demod
Table 2-2,
is grayed out if the
87