Agilent Technologies PSA Series User And Programming Manual page 259

4.9.5.4 Host ID (Remote Command Only)
Enables you to query the host ID remotely. The current value of the host ID can be viewed
on the display by pressing
SCPI Status Bits/
OPC Dependencies: None
Factory
Default: Value is unique to your instrument (Not reset by
Defaults
Remote Command:
:SYSTem:HID?
Remote Command Notes: The host ID cannot be set remotely, it can only be queried.
Example:
SYST:HID?
4.9.5.5 Subnet Mask
Changes the subnet mask of the instrument. The subnet mask is a 32-bit address mask
used in IP networks to indicate the bits of an IP address that are used for the subnet
address. The default address is 255.255.0.0 for a class B network
Key Path:
System
Survives
State Saved:
Factory
255.255.0.0 (Not reset by
Default:
Added with firmware revision A.03.00.
History:
Remote Command:
There is no equivalent remote command.
4.9.5.6 Gateway Address
Allows you to set the gateway address. The gateway address feature is used to manipulate
the gateway used to reach the destination. The gateway address can be changed by
entering a numeric address composed of numbers and decimal points. Press
complete the entry.
Key Path:
System
Survives
State Saved:
Factory
0.0.0.0 (Not reset by
Default:
Added with firmware revision A.03.00.
History:
Chapter 4
System, Show System
.)
,
Config I/O
and power cycle, but not saved in Instrument State.
Preset
System
,
Config I/O
and power cycle, but not saved in Instrument State.
Preset
,
System
.
System
,
Restore Sys Defaults
.)
Restore Sys Defaults
Instrument Functions: P - Z
System
,
Restore Sys
.)
to
ENTER
259