Select Marker; Normal - Agilent Technologies PSA Series User And Programming Manual

Remote Command Notes: The :CALC:MARK:PEAK:SEARC:MODE MAX|PAR command
specifies how a peak is identified for use with the marker commands. See
"Peak Search" on page
Example: CALC:MARK:MODE POS selects marker 1 and sets it to
CALC:MARK2:X 20 GHZ selects marker 2 and moves it to 20 GHz. (Marker
2 must first be turned on.)

Select Marker

3.1.1
Selects one of the four possible marker or marker pairs. Once a marker is selected, it can
be set to any of the control modes,
Key Path:
Marker
State Saved: The number of the selected marker is saved in instrument state.
Factory Preset: Marker 1
Remote Command:
:CALCulate:MARKer[1]|2|3|4:STATe OFF|ON|0|1
:CALCulate:MARKer[1]|2|3|4:STATe?
Sets or queries the state of a marker. Setting a marker to state ON or 1 selects that
marker. Setting a marker which is OFF to state ON or 1 puts it in
it at the center of the display. Setting a marker to state OFF or 0 selects that marker and
turns it off. The response to the query will be 0 if OFF, 1 if ON.
Example: CALC:MARK2:STAT ON selects marker 2.
CALC:MARK:STAT ON will not modify a marker that is already on.

Normal

3.1.2
Sets the control mode for the selected marker to
marker is off, a single marker is activated at the center of the display. The marker stays on
the trace at the horizontal screen position where it was placed unless
"marker to" key function (such as
) is selected. If you are in a marker pair mode, for example
Search
reference marker is turned off. You can then adjust the trace point of the marker.
Key Path:
Marker
Remote Command:
See "Marker" on page 167
Example: :CALC:MARK:MODE POS selects marker 1 and sets it to
Chapter 3
209.
, ,
Normal Delta Delta Pair
Normal
Mkr → CF Mkr → RL
,
for the mode command.
Instrument Functions: M - O
.
Normal
, , or .
Span Pair Off
mode and places
Normal
(see "Marker" on page
Signal Track
Mkr → CF STEP Mkr ∆ Span
, ,
Delta Marker
Normal
Marker
167). If the
, or a
, or
Min
, the
.
169