Agilent Technologies PSA Series User And Programming Manual page 104

Instrument Functions: A - L
Display
−3 kHz to 350 GHz; −30 Gsec to 30 Gsec
Range:
History: Added with firmware revision A.03.00
2.5.5.1.5.3 Amplitude
Pressing allows you to enter the amplitude value for the current limit point. After entering a value,
Amplitude
becomes active. If a front-panel arrow key is pressed without entering a value, the current
Connected
and values of the point are selected. If the up arrow is pressed, the point number automatically
Connected
increments to allow entry of the amplitude of the next point. If it is a new point, the
entered for the new point.
Key Path: ,
Display
,
Display
Factory Preset
and *RST: 0 dBm
Fundamental
Units: dBm
Terminators: dBm
Default Terminator: dBm
Resolution: 0.1 dBm
Knob Increment: 0.1 dBm
Step Key
Increment: 10 dBm
Range: -140 dBm to 100 dBm
History: Added with firmware revision A.03.00
2.5.5.1.5.4 Connected To Previous Pt
A current point may be connectd to the previous point by pressing
disconnected points. Pressing this key when the Connected field is selected toggles the connected value of the
current point and increments the Point number to allow entry or editing of the Frequency of the next point. If
an arrow key is pressed without entering a value, the current Connected value of the point is selected. If an
arrow key is pressed, the Point number automatically increments to allow entry of the Connected value of the
next point. If it is a new point, the
Key Path: ,
Display
,
Display
Factory Preset
and *RST: Yes
Knob Increment: Toggles to other selection.
Step Key
Increment: Toggles to other selection
History: Added with firmware revision A.03.00
104
, ,
Limits Limit 1 Edit
, ,
Limits Limit 2 Edit
may be entered for the new point
Frequency
, ,
Limits Limit 1 Edit
, ,
Limits Limit 2 Edit
Frequency
. No limit testing is performed between
Yes
Amplitude
may also be
Chapter 2