Remote Command:
:CALCulate:LLINe[1]|2:TYPE UPPer|LOWer
:CALCulate:LLINe[1]|2:TYPE?
Example:
:CALC:LLIN2:TYPE LOW sets limit line 2 as a lower limit.
:CALC:LLIN1:TYPE? responds with the limit line 1 limit type.
2.5.5.1.2 Limit Display
Turns limit-line display
turn on a limit test.
Key Path:
Display
Display
State Saved:
Not saved in instrument state.
SCPI Status Bits/
OPC Dependencies: No OPC dependencies.
Factory Preset
and *RST:
Off
Factory
Default:
Off (when a limit line is created)
History:
Added with firmware revision A.03.00
Remote Command:
:CALCulate:LLINe[1]|2:DISPlay OFF|ON|0|1
:CALCulate:LLINe[1]|2:DISPlay? queries the current limit line.
Example:
:CALC:LLIN2:DISP OFF turns off the display of the limit lines.
:CALC:LLIN1:DISP? tells you whether the limit lines are being displayed.
Chapter 2
or
. Either
On
Off
Limit
,
,
Limits
Limit 1
,
,
Limits
Limit 2
or
, as well as
Margin
Test
Instrument Functions: A - L
Display
, must be turned on to
99