Agilent Technologies PSA Series User And Programming Manual page 209

4.1.8.3 Peak Search
Sets the mode for
Peak Search
(Maximum mode) places a marker on the highest peak whenever a
• Max
performed.
(Parameter mode) searches only for peaks that meet the values set with
Param
•
and
Excursn Pk Threshold
.
Key Path:
Peak Search
State Saved: Saved in instrument state.
Factory Preset: Maximum
Factory
Default: Maximum.
Remote Command:
:CALCulate:MARKer:PEAK[1]|2|3|4:SEARch:MODE PARameter|MAXimum
:CALCulate:MARKer:PEAK[1]|2|3|4:SEARch:MODE?
Remote Command Notes: If mode is set to MAXimum (Max), peak search will place the
marker at the maximum amplitude in the trace. If mode is set to
PARameter (Param ), peak search will place the marker at the highest
peak that rises and falls by at least the peak excursion above the peak
threshold. If no peak meets the excursion and threshold criteria, a No
Peak Found error (error 202) is issued.
The following commands are not affected by the setting of
CALC:MARK:PEAK SEAR:MODE. They will always use the parameter
search mode that defines peaks based on peak excursion and peak
threshold.
:CALCulate:MARKer[1]|2|3|4:MAXimum
:CALCulate:MARKer[1]|2|3|4:MAXimum:LEFT
:CALCulate:MARKer[1]|2|3|4:MAXimum:NEXT
:CALCulate:MARKer[1]|2|3|4:MAXimum:RIGHt
:CALCulate:MARKer:PEAK:TABLe:STATe OFF|ON|0|1
Chapter 4
to either or
Max Param
.
,
Search Param
Instrument Functions: P - Z
and applies to
Peak Search
Peak Search
Peak Search
only.
is
Peak
209