Agilent Technologies PSA Series User And Programming Manual page 53

2.1.11.2.2.3 Amplitude
Allows you to enter the amplitude value for the current amplitude-correction point. After entering
an amplitude, the point number automatically increments and
entry of the frequency of the next point.
Key Path: AMPLITUDE / Y Scale, More, Corrections, Antenna (Cable, Other, or User), Edit
State Saved: Not part of instrument state, saved in a corrections file.
Remote Command:
"Edit" on page 51.
See
2.1.11.2.2.4 Delete Point
Allows you to delete the amplitude-correction data for the currently selected point. The prompt "If
you are sure, press key again to delete" will appear on the display. Pressing
again will delete the point and adjust all of the point numbers as appropriate.
Key Path: AMPLITUDE / Y Scale, More, Corrections, Antenna (Cable, Other, or User), Edit
Remote Command:
"Edit" on page 51.
See
2.1.11.2.3 Delete Corrections
Allows you to clear all data from the selected amplitude-correction set. The prompt If you
are sure, press key again to delete will appear on the display. Pressing
will delete the correction set.
Key Path:
AMPLITUDE / Y Scale
Remote Command:
[:SENSe]:CORRection:CSET[1]|2|3|4:DELete
Remote Command Notes: CSET number equivalents to front-panel access definitions are
as follows:
CSET or CSET1 is Antenna
CSET2 is Cable
CSET3 is Other
CSET4 is User
Example:
CORR:CSET4:DEL
Chapter 2
Frequency
, , ,
More Corrections Antenna
Instrument Functions: A - L
AMPLITUDE / Y Scale
becomes active to allow
Delete Point
again
Delete
( , , or )
Cable Other User
53