Agilent Technologies PSA Series User And Programming Manual page 258

Instrument Functions: P - Z
System
4.9.5.2 IP Address
Allows you to set the IP (internet protocol) address, domain name and node (host) name for
the instrument. The IP address of the instrument can be changed by entering a numeric
address composed of numbers and decimal points. Press
Key Path:
System
Survives
State Saved:
Factory
199.199.199.199 (Not reset by
Default:
Remote Command:
:SYSTem:COMMunicate:LAN[:SELF]:IP <string>
:SYSTem:COMMunicate:LAN[:SELF]:IP?
Example:
SYST:COMM:LAN:IP "150.222.50.52 mypsa"
Sets the IP address to 150.222.50.52 and sets the host name to mypsa.
4.9.5.3 Host Name
Displays the host name of the instrument. Pressing the key activates the alpha editor,
which enables you to change the host name. (Press
This will not change your LAN system representation of the host name. You
NOTE
must work through your local system administrator to change the host name.
Changing it in the instrument only changes the displayed information, it will
not enable LAN access with the new name.
Key Path:
System
Survives
State Saved:
Factory
mypsa (Not reset by
Default:
Remote Command:
See above command :SYSTem:COMMunicate:LAN[:SELF]:IP <string>
Example:
SYST:COMM:LAN:IP "150.222.50.52 mypsa"
Sets the IP address to 150.222.50.52 and sets the host name to mypsa.
258
,
Config I/O
and power cycle, but not saved in Instrument State.
Preset
,
Config I/O
and power cycle, but not saved in Instrument State.
Preset
,
System Restore Sys Defaults
to complete the entry.
ENTER
,
System Restore Sys Defaults
to complete the entry.)
ENTER
.)
.)
Chapter 4