Diagmessages of module AxisMain
6.55
8183, Controlword output cycle counter monitoring
The output cycle counter of the controlword didn't increment for at least two cycles and the monitoring
function is activated.
Diagnostic Code (Hex.)
8183
Class
Error
Standard Reaction
Closed loop ramp
Possible Causes
The Output cycle counter monitoring is enabled and
detected an error.
Internal: 0x8183, Controlword output cycle counter monitoring
154
Diagnostic Code (Dez.)
33155
Type
Error
Reset
Execute Reset-Command (Fault reset).
Solutions
Check if the output cycle counter function is enabled
in your NC. Check your EtherCAT realtime status.
Version: 1.1
Multi axis servo system - AX8000