Diagmessages Of Module Devicemain; 3210, Dc Link Overvoltage - Beckhoff AX8000 User Information

4

Diagmessages of module DeviceMain

4.1

3210, DC link overvoltage

DC link overvoltage because the brake power of the power supply module is too low.
Diagnostic Code (Hex.)
3210
Class
Error
Standard Reaction
Torque off
Possible Causes
Parameterization of the brake chopper from the
power supply module is wrong.
The brake resistor from the power supply module is
defective
Wrong selection of the brake resistor from the power
supply module.
Internal: 0x3210, DC link overvoltage
Multi axis servo system - AX8000
Diagmessages of module DeviceMain
Diagnostic Code (Dez.)
12816
Type
Overvoltage error
Reset
Execute Reset-Command (Fault reset).
Solutions
Check the parameterization of the brake chopper
from the power supply module.
Measure the current resistance of the brake resistor.
Check the resistance of the brake resistor. Check the
power of the brake resistor.
Version: 1.1 83