12.7
638F, Parameter Torque Control: The value in Object is
higher then the Motor maximum voltage slope
The voltage slope of the parametrized motor is not valid for this drive
Diagnostic Code (Hex.)
638F
Class
Error
Standard Reaction
Axis is inoperable
Possible Causes
Something is wrong with the parameters in this
object.
Internal: 0x638F, Parameter Torque Control: The value in Object 0x%x/%x is higher then the Motor
maximum voltage slope (0x%x/%x).
Multi axis servo system - AX8000
Diagmessages of module TorqueControl
Diagnostic Code (Dez.)
25487
Type
Error
Reset
Execute Reset-Command (Fault reset).
Solutions
Please check the parameters of the mentioned
object.
Version: 1.1
191