5590, Detected Incompatible Pcb - Beckhoff AX8000 User Information

Standard-Messages
3.10

5590, Detected incompatible Pcb

Detected incompatible Pcb for this Firmware.
- ID 0: ControlPcb
- ID 1: FrontPcb
- ID 2: AdditionalAxisPcb
- ID 3: DisplayPcb
- ID 6: SafetyPcb
- ID 7: CpuPcb
Diagnostic Code (Hex.)
5590
Class
Error
Standard Reaction
Torque off
Possible Causes
This Hardware is unsupported of this Firmware.
The HardwareRevision is unsupported.
The HardwareType is unknown.
Internal: 0x5590, Detected incompatible Pcb at ID %u.
24
Diagnostic Code (Dez.)
21904
Type
Error
Reset
A reset is not possible. The drive detected a fatal
hard- or software error.
Solutions
Disconnect the power supply module from the mains
(including the 24 V power supply) and start a new
attempt. If this error occurs repeatedly, please call
the Beckhoff support that is responsible for you.
Disconnect the power supply module from the mains
(including the 24 V power supply) and start a new
attempt. If this error occurs repeatedly, please call
the Beckhoff support that is responsible for you.
Disconnect the power supply module from the mains
(including the 24 V power supply) and start a new
attempt. If this error occurs repeatedly, please call
the Beckhoff support that is responsible for you.
Version: 1.1 Multi axis servo system - AX8000