Installation; Checking The Shipment; Place Of Installation And Ambient Conditions - ABB REG316 4 Series Operating Instructions Manual

REG 316*4 1MRB520049-Uen / Rev. C
7.2.

Installation

7.2.1.

Checking the shipment

Check that the consignment is complete upon receipt. The near-
est ABB agent must be notified immediately should there be any
discrepancies in relation to the delivery note, shipping papers or
the order.
Visually check the state of all items when unpacking them. Should
any damage be found, the last carrier must be informed imme-
diately followed by a claim in writing pointing out his responsibility
for the damage. Also inform your nearest ABB office or agent and
ABB Switzerland Ltd, Department UTAAA-P, CH-5401 Baden, Swit-
zerland.
If the equipment is not going to be installed immediately, it must
be stored in a suitable room in its original packing.
7.2.2.

Place of installation and ambient conditions

When choosing the place of installation, ensure that there is suf-
ficient space in front of the equipment, i.e. that the serial inter-
face connector and the local control and display unit are easily
accessible.
In the case of semi-flush mounting or installation in 19" equip-
ment racks, space behind the equipment must be provided for
adding ancillary units (e.g. 316DB61 and 316DB62), replacing
units and changing electronic components (firmware).
Since every piece of technical equipment can be damaged or
destroyed by inadmissible ambient conditions,
· the relay location should not be exposed to excessive air
pollution (dust, aggressive substances)
· severe vibration, extreme changes of temperature, high lev-
els of humidity, surge voltages of high amplitude and short
rise time and strong induced magnetic fields should be
avoided as far as possible
· air should be allowed to circulate freely around the equip-
ment.
The equipment may be mounted in any attitude, but is normally
mounted vertically (for reading the display and frontplate mark-
ings).
ABB Switzerland Ltd
7-3