Ibb Status Information; Process Bus Information - ABB REG316 4 Series Operating Instructions Manual

ABB Switzerland Ltd
The status of the device is at the top of the list followed by the
time when the software was downloaded, the time when settings
were last changed and finally the statuses of an FUP programs
that are loaded.
-Diagnosis Info-
Relay–Status:
No Error
Fig. 5.108
5.13.8.5.2.

IBB status information

Select this menu item to view information on the interbay bus
(LON, MVB etc.). The name "IBB StatusInfo" is in the header
followed by three lines with the IBB diagnostic information. You
can scroll through the list using the "^" and "v" keys:
· The interbay bus connected (SPA, VDEW, LON or MVB) is
shown on the second line together with the information
'Ready' (operational), 'No response' (if no telegrams are
transferred, but the device is ready) or 'Inactive' (this ap-
pears, for example, when the corresponding interface is not
fitted). The HMI on the PC must be used to obtain more de-
tailed information.
· Station number and the time
· Neuron chip ID (LON only)
-IBB Status Inf-
SPA-BUS
Ready
Fig. 5.109
5.13.8.5.3.

Process bus information

Here information about the process bus can be viewed in a
similar manner to information about the station bus. The name
"ProcessbusInfo" is in the header and the operating mode, the
status of the PC card, the PC card type, the software version
and the PC card counter appear below.
5-120
REG 316*4 1MRB520049-Uen / Rev. E
â
General status information
Interbay bus information