ABB REG316 4 Series Operating Instructions Manual page 386

ABB Switzerland Ltd
Several files plotxxx.txt with different station numbers (xxx) can
be combined to a single plot.txt. The file plot.txt must be at the
same location as the disturbance recorder data for the REVAL
evaluation program.
Example:
PLOT.TXT (existing file), plot020.txt (data for station No. 20) and
plot021.txt (data for station No. 21) can be combined using the
DOS command:
C:\REL316
C>copy PLOT.TXT+plot020.txt+plot021.txt PLOT.TXT
The file PLOT.TXT can be modified using an editor.
The evaluation is based on data expressed as multiples of UN or
IN.
Instructions for installing the data evaluation program
The data evaluation program must be installed in strict accor-
dance with the relative operating instructions.
WINEVE
Copy the file "PLOT.TXT" to the directory:
C:\I650\EVENTS
A disturbance should be recorded during the commissioning of
every relay and the record stored in the directory given above.
The procedure for installing the station parameter files is as fol-
lows:
·
Start the WINEVE program.
· Open a fault record
The following error message appears:
C:\I650\STATION\ST0xx.PAR
Could not find file.
· Click on OK.
·
Select the menu item "Import station file" in the "Parameter"
menu.
· Select the file PLOT.TXT belonging to this disturbance re-
cording.
3-348
REG 316*4 1MRB520049-Uen / Rev. F