ABB REG316 4 Series Operating Instructions Manual page 808

ABB Switzerland Ltd
10.9.4. New processor unit 316VC61b
Version 6.0 supports the new 316VC61b processor unit. To
determine whether a device contains a 316VC61b processor
unit or not, open 'List diagnostic information' in the HMI
diagnostic function and check the code '04Ax' on line 'HW No.':
10.10. Changes in Version Version 6.2 in relation to Version 6.0
10.10.1. Analogue input/output unit 500AXM11
Versions from V6.2 onwards support the analogue input/output
unit 500AXM11 of the distributed input/output system RIO580.
10.10.2. 'Analogue RIO Trigger' function
An 'Analogue RIO Trigger' function has been added to the
function block library which is available for all software keys and
facilitates the supervision of the input signals of the analogue
input/output unit 500AXM11. Refer to the Operating Instructions
for the distributed input/output system RIO580, Publication
1MRB520192-Uen, for further details.
10.10.3. Measurement module
The 'MeasureModule' function has been added to the function
block library. It is available for all software keys and facilitates the
three-phase measurement of voltage, current, active and reactive
power, power factor and frequency. Two counter impulse inputs
are also provided for metering energy.
10.10.4. Commands via a Stage 2 LON bus
In automation systems equipped with a Stage 2 LON interbay
bus, commands can be transferred from the automation system
to the bay units.
10.11. Changes in Version 6.3 in relation to Version 6.2
10.11.1. A/D converter unit 316EA63
From Version V6.3, the software supports the new A/D converter
unit 316EA63 which supersedes the previous plug-in unit 316EA62 .
10-6
HW No.: xxxx/04Ax/xx
REG 316*4 1MRB520049-Uen / Rev. G