ABB REG316 4 Series Operating Instructions Manual page 561

REG 316*4 1MRB520049-Uen / Rev. E
Analogue inputs and outputs
Since the selection and display of the analogue inputs and ana-
logue outputs are very similar, the following example only illus-
trates the selection and presentation for analogue inputs.
The "Analogue Signals" menu provides a choice between inputs
and outputs. The "Input Signals" menu shows the numbers of all
the devices that have been configured to enable the one to be
selected for which the input signals should be displayed.
-Analogue Signals
Input signals
Output signals
Fig. 5.101 Analogue signals
-Input signals
Device No.
Device No. 10
Fig. 5.102 Input signals
Displaying analogue variables
This menu lists all the measurements of the device selected
which can be displayed. The device number is in the menu
header and the measurements are listed below. The measure-
ments in the list can be viewed using the "^" and "v" buttons.
Since this is the lowest menu level in this branch, the buttons "E"
and ">" have no effect.
-Device No.
1 14.01 mA
2 2.52 V
3 143.42 °
Fig. 5.103 Viewing the input variables of device No. 9
9
9-
â
ABB Switzerland Ltd
5-117