ABB REG316 4 Series Operating Instructions Manual page 594

ABB Switzerland Ltd
The table below explains the significance of the various items of
information.
Neuron Chip ID-No.
LON interface ID
Domain
Subnet No.
Node No.
Transmission errors
Transaction timeouts
Receiver transaction
timeouts
Lost messages
Missed messages
Reset cause
Interface Status
Version number
Error number
Model number
Driver state
Cross table for
network variables
No. of semaphore hits Information for ABB purposes
No. of semaphore
misses
No. of semaphore
fails
No. of IN buffer
overflows
No. of transmitted
messages
No. of received
messages
6-10
REG 316*4 1MRB520049-Uen / Rev. C
Hardware number of the neuron chip on the PC card
Must always be set to "DP_MIP".
Number of the domain to which the device belongs
(can be set via the LON bus).
Number of the sub-network to which the device
belongs (can be set via the LON bus).
Device node number (can be set via the LON bus).
Number of errors detected during reception.
Number of transaction confirmations not received.
Number of messages received that were lost,
because of incorrect settings at the receiving end.
Number of messages lost, because the receive
memory in the RE.316*4 was full.
Number of messages lost, because the receive
memory on the PC card was full.
Reason for the last restart executed by the PC card.
Normal: "Configured and on-line".
PC card firmware version
0 = no error or error on the PC card.
Always 0
OK or error message
Valid or invalid (table loaded via the LON bus).
Information for ABB purposes
Information for ABB purposes
Number of messages lost, because the driver buffer
was full.
Total number of messages transmitted since the
information was deleted.
Total number of messages received since the
information was deleted.