Set Product Id - Avaya S8700 Installing Manual

24 Migrating to an Avaya™ S8700 Media Server with Avaya™ MCC1 or SCC1 Media Gateway
Configure Media Server 1
Configure Media Server 1
You must configure each media server in turn. This section covers the following tasks:
''Power up media server 1'' on page 24
•
''Set product ID'' on page 24
•
''Connect and log into the Web Interface'' on page 25
•
''Set date and time'' on page 27
•
• ''Verify software version'' on page 27
''Set media server configuration type'' on page 28
•
''Upgrade media server software (if necessary)'' on page 28
•
• ''Continue server 1 configuration'' on page 29
''Install license and Avaya authentication files'' on page 33
•
• ''Verify media server 1 connection to customer's LAN (if provided)'' on page 35
''Test media server 1 LEDs'' on page 37
•
''Configure SNMP traps'' on page 38
•
• ''Disconnect from media server 1'' on page 39
NOTE:
Make sure you have the filled-out job aid titled Pre-Installation Network Planning
Forms—S8700 Media Server before beginning this process.
NOTE:
Make sure your networking and Web browser settings are correct. Refer to the job aid
entitled
Power up media server 1
Plug the AC power cord for media server 1 into UPS 1 to power it up. Refer to
1
Started with the Avaya™ S8700 Media Server with an Avaya™ G600 Media
Gateway.

Set product ID

You must assign a product ID number to the configuration. You can obtain this product ID
number from the Automatic Registration Tool (ART) script.
1 Click Start > Run to open the Run dialog box
2 Type telnet 192.11.13.6 and press
Log in as craft.
3
4 At the prompt type
Pre-Installation Information—Avaya™ S8700 Media
productid -p
May 2003
.
Enter
and press
number
Enter
Server.
Getting
.