Roll Feeding Motor Assy; Removing The Roll Feeding Motor Assy - Epson Stylus Pro 4910 Service Manual

Epson Stylus Pro 4900/Epson Stylus Pro 4910

3.4.7.4 Roll Feeding Motor Assy

1. Remove the Right Roll Cover. (p151)
2. Remove the SUB-D Board. (p164)
3. Remove the "HOLDER,ROLLER,RIGHT".
Lock Sensor" (P. 217))
4. Remove the Motor Assy. (Step 4
5. Disconnect the connector from the Roll Feeding Motor Assy.
6. Remove the planetary gear.
When installing the planetary gear, be careful of the installation
direction referring to
7. Remove the two screws that secure the Roll Feeding Motor Assy, and remove the
Roll Feeding Motor Assy.
A) Silver, Phillips, Pan machine screw M2.6x4: two pieces
When installing the Roll Feeding Motor Assy, be careful of the
installation direction referring to
Be sure to refer to Chapter 4 "Adjustment"
A D J U S T M E N T
R E Q U I R E D
specified adjustment after replacing the Roll Feeding Motor Assy.
<Adjustment item>
Counter Reset (Roll Feeding Motor Counter)
DISASSEMBLY & ASSEMBLY
(Step 3 to Step 8 in "3.4.7.2 Roll
to Step 6 in "3.4.7.3 ATC Motor Assy"
Figure 3-151.
Figure 3-151.
(see p277) and perform
Disassembly and Assembly Procedure
Connector
(P. 219))
Figure 3-151. Removing the Roll Feeding Motor Assy
Roll Feeding Motor Assy
Planetary gear
A
A
Revision A
220
Confidential