Exit Lower Assembly Removal (Pl10.1.1); Roll Assembly Removal (Pl10.2.5) - Epson ColorPage EPL-C8000 Service Manual

EPSON EPL-C8000

3.2.13.3 EXIT LOWER ASSEMBLY Removal (PL10.1.1)

1. Remove the TOP COVER ASSEMBLY. (See Section 3.2.4.3.)
2. Remove the REAR COVER ASSEMBLY. (See Section 3.2.4.5.)
3. Remove the FUSER ASSEMBLY with the EXIT TRAY ASSEMBLY
and the OIL ROLL ASSEMBLY on it. (See Section 3.2.12.2.)
4. Remove the EXIT UPPER ASSEMBLY. (See Section 3.2.13.2.)
5. Disconnect 3 connectors (P/J111B, P/J161B, P/J89) for the EXIT
LOWER ASSEMBLY.
6. Remove 5 screws (black, cup head, 8mm) securing the EXIT
LOWER ASSEMBLY, and remove the EXIT LOWER ASSEMBLY
by lifting it up.
Figure 3-118. EXIT LOWER ASSEMBLY Removal
Chapter 3 Disassembly and Assembly/Adjustment
3.2.13.4 EXIT-2 ROLL ASSEMBLY Removal (PL10.2.5)
1. Remove the TOP COVER ASSEMBLY. (See Section 3.2.4.3.)
2. Remove the REAR COVER ASSEMBLY. (See Section 3.2.4.5.)
3. Remove the FUSER ASSEMBLY with the EXIT TRAY ASSEMBLY
and the OIL ROLL ASSEMBLY on it. (See Section 3.2.12.2.)
4. Remove the EXIT UPPER ASSEMBLY. (See Section 3.2.13.2.)
5. Remove the EXIT LOWER ASSEMBLY. (See Section 3.2.13.3.)
6. Remove 2 E-rings securing the EXIT-2 ROLL ASSEMBLY by the
front and rear ends, and remove 2 SPUR GEARs, EXIT FRONT
BEARING, and the EXIT REAR BEARING.
7. Remove the EXIT-2 ROLL ASSEMBLY.
Figure 3-119. EXIT-2 ROLL ASSEMBLY Removal
Revision B
3-99