Pre-Regi. Roll Assembly Removal (Pl5.2.4) - Epson ColorPage EPL-C8200 Service Manual

EPSON ColorPage EPL-C8200

3.2.8.6 PRE-REGI. ROLL ASSEMBLY Removal (PL5.2.4)

1. Remove the MSI TRAY ASSEMBLY. (See Section 3.2.7.1.)
2. Remove the MSI ASSEMBLY. (See Section 3.2.7.2.)
3. Remove the MAIN P/H ASSEMBLY. (See Section 3.2.8.1.)
4. Remove the PRE-REGI. CHUTE ASSEMBLY. (See Section
3.2.8.4.)
5. Remove the PRE-REGI. CLUTCH. (See Section 3.2.8.5.)
6. Remove the E-ring fixing the TURN IDLER GEAR, and then remove
the TURN IDLER GEAR and the PRE-REGI. BEARING on the rear.
7. Pull the PRE-REGI. KNOB ASSEMBLY out of the PRE-REGI.
ROLL ASSEMBLY to remove.
NOTE: In the following step, make sure you won't leave the MSI
OUT HOLDER too far from the MSI FRAME ASSEMBLY,
since they are kept connected with the harness.
8. Remove 2 screws (gold, tapped, 8mm) securing the MSI OUT
HOLDER and separate the MSI OUT HOLDER from the MSI
FRAME ASSEMBLY.
9. Remove the E-ring in the front securing the PRE-REGI. ROLL
ASSEMBLY, and then, using a standard screw driver, remove the
PRE-REGI. BEARING in the front.
10. Lifting the PRE-REGI. ROLL ASSEMBLY up keeping it level, turn
the assembly to align the pin on it with the cutout in the P/H FRAME
ASSEMBLY, and shift the assembly backward.
11. Lift up the front end of the PRE-REGI. ROLL ASSEMBLY and pull it
out to the upper front, and remove the PRE-REGI. GEAR 2 and
PRE-REGI ROLL ASSEMBLY respectively.
Chapter 3 Disassembly and Assembly/Adjustment
Figure 3-49. PRE-REGI. ROLL ASSEMBLY Removal
Revision A
3-43