Adjustment Of The Radf - Toshiba e-STUDIO2006 Service Manual

6.10 Adjustment of the RADF

6.10.1 Tray volume adjustment
[A] General description
Perform this adjustment when the original tray (volume) or the RADF board is replaced.
[B] Adjustment Method
(1) Turn the power ON while pressing [0] and [5] simultaneously.
(2) Minimize the width of the side guide of the tray.
[3050]  [START]
(3)
The tray volume adjustment starts. When the adjustment is completed properly, the adjustment
value (100 or less) and "COMPLETED" are displayed.
Notes:
If the adjustment value is out of the appropriate range, "ERROR" is displayed on the screen. In
this case, press the [CANCEL] button and confirm that the width of the side guide is minimized.
Then reattempt the procedure from step (2).
(4) Press the [OK] button.
(5) Maximize the width of the side guide of the tray.
[3051]  [START]
(6)
The tray volume adjustment starts. When the adjustment is completed properly, the adjustment
value (200 or more) and "COMPLETED" are displayed.
Notes:
If the adjustment value is out of the appropriate range, "ERROR" is displayed on the screen. In
this case, press the [CANCEL] button and confirm that the width of the side guide is maximized.
Then reattempt the procedure from step (5).
(7) Press the [OK] button.
(8) Turn the power OFF with the main power switch.
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
6 - 41
SETTING / ADJUSTMENT
6