Toshiba e-STUDIO2006 Service Manual page 265

Procedure 6
(Test copy)
[STAR T]
[SETTINGS]
[0][5]
[POWER]
* When the automatic adjustment ends abnormally, error message is displayed. Return to "TEST
MODE A" screen by pressing the [CANCEL] button.
Procedure 7
(Test copy)
[STAR T]
[SETTINGS]
[0][5]
[POWER]
When the automatic adjustment ends abnormally, error message is displayed. Return to "TEST MODE
A" screen by pressing the [CANCEL] button.
Procedure 10
(Test copy)
[START]
[SETTINGS]
[0][5]
[POWER]
Procedure 17
(Test copy)
[START]
[SETTINGS]
[0][5]
[POWER]
* The automatic adjustment starts when 2 minutes have passed after the [START] button is pressed.
Notes:
The fuser roller temperature control at the adjustment mode is different from that at the normal
state.
Therefore, the problem of fusing efficiency may be occurred in the test copy at the adjustment
mode. In that case, turn ON the power normally, leave the equipment for approx. 3 minutes after
it has become ready state and then start up the adjustment mode again.
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
[START]
(Code)
*[CANCEL]
Automatic
(
(Code) [START]
adjustment
*[CANCEL]
[Digital key]
[START]
(Code)
(Sub code)
(Value unchangeable)
[CLEAR/STOP]
[START]
(Code)
[DOWN]
(Adjust a value)
e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
5 - 9
Automatic
( )
[OK]
adjustment
Select "Yes"
)
or "No" using
the arrow button
(Select)
(
[START]
[OK]
[UP]
[OK]
or
Stores value
[POWER]OFF/ON
(Exit)
[POWER]
[OK]
OFF/ON
(Exit)
[POWER]
Value
)
OFF/ON
displayed
(Exit)
[POWER]
OFF/ON
(Exit)
SELF-DIAGNOSIS MODES
5