Process Unit <23La/23Lm/28Lm/23Ha/28Ha> - Toshiba e-STUDIO2006 Service Manual

4.7.2 Process unit <23LA/23LM/28LM/23HA/28HA>
Notes:
1. Immediately after power OFF, the fuser unit entrance guide is very hot and can cause burns.
Wait for it to cool down before starting work.
2. Make sure to perform "05-2390" and take off the process unit before the developer material is
replaced.
(1) Pull out the toner cartridge.
(2) Open the right cover.
(3) Disconnect 1 connector [1].
Notes:
When holding the process unit, do not touch
the conveyance guide of the developer unit.
Pushing the guide too strongly may damage
the drum.
(4) Push the lever [2] and release the lock.
Notes:
Check the marked lines and push the lever to
the position shown in the figure.
e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
DISASSEMBLY AND REPLACEMENT
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
4 - 50
[1]
Fig. 4-127
[2]
Fig. 4-128
Fig. 4-129