Toshiba e-STUDIO2006 Service Manual page 415

[E440] Feed cover opened during printing
Classification
Cover open jam
Proce
Check item
dure
1 Is the feed cover open?
Is the feed cover opening/
2
closing detection sensor
working?
(Perform the input check
in the test mode: 03-[A]/
[E])
3 Replacing board
Parts to be replaced
Feed cover opening/closing
detection sensor
MAIN board
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
Feed cover open jam
Result
Yes Remove the paper if there is any, then close
the cover.
No
Yes
No • Check if the connector of the feed cover
opening/closing detection sensor is
disconnected.
• Check if any of the connectors on the MAIN
board is disconnected.
20L/23L/25L/20H/23H/25H: CN27
23LA/23LM/28LM/23HA/28HA: CN16
• Check if the connector pins are
disconnected and the harnesses are open
circuited.
• Check if the conductor pattern on the MAIN
board is short circuited or open circuited.
• Replace the feed cover opening/closing
detection sensor.
• Replace the MAIN board.
e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
8 - 37
Error content
Measure
Remark
ERROR CODE AND TROUBLESHOOTING
Next
Step
2
3
8